Issues on a map I am building

I have some problems with a map I have created, but the problem is not with the lap itself.

1. I an using the Vanhool busses from the free DLC. But the buses with rollband are not showing line number as they not have any line rollbands. Some of them have place for line in the destination rollband, Any idea how I could use that feuture, cause if I am give each line its own destination every AI bus showing the empty display.

2. Most of the AI buses do not have a driver, how do I get a driver in every AI bus?

3. Is there any way to prevent buses from disappear after every run from the busstation to B, and from B back to Busstation. After that the bus disappears. It may have something with that I have two different stops for disembark and embark, which I implemented cause it was too much buses at the same time in the station area, and blocked each other it become a big mess, there. Any Idea how to solve theses 3 things?

Ok.

1. I know about the rollband texture, I have created those. And I have it working correctly but, the issue is that those buses are suoposed to show the terminus and line on the same rollband, wich means each line need to have the its own terminuscode, and when I make it so in the hof-file then they show terminus 0.

2. As I can see there are only a setting about Busdriver in own buss. Bu this issue is with the AI.

3. Ok. I will check that out.

Zitat von tfc

1. You have to create Rollband textures, otherwise you will not see line and end station (terminus)

2. I'm not sure about that, but I think there is some option in the settings which hide drivers in busses - try to turn it on.

3. In the timetable editor, the space between two trips have to be black (check Gründorf map). If it's white, it means that two trips aren't "connected".

That means following: First path of the second trip (backward Tour) have to start at the last path of the trip before. This is only working for standard method (without using StarionsLinks). If you are using StationsLinks, it's needed to be done another way.

And if you fix it correctly, space between two trips in the timetable will be black which is correct.

I would recommend you to check some tutorials how to create new T&T.

Alles anzeigen

First I am quite sure I know how to make a timetable and trips and tracks, but thanks for the advice. Btw I have now tried to get the pace between the tours black but still it is not working, the bus is still disappear. I shall explain it further. My idea is as follows and it meant to be implemented on all lines. (I have used Line 1to test it with) the idea is:

Line 1 Start at 6am the busstation position A and go to the church there it arrives 6.15am, 6.20 it is going back to the busstation there it arrive 6.35 (stoping at a disembark stop), 6.36 it going to a parking (a no entry busstop) 6.56 uts going back into the station area to position A and 7 00, it all starting over but instead of pickup the passengers the bus disappears.

Using type 1 trips btw